It means the Phase 1 algorithms doesn’t match the gateway configuration.Ģ0090429 114920 Default (SA Cnx-P1) SEND phase 1 Main Mode Ģ0090429 114920 Default (SA Cnx-P1) RECV phase 1 Main Mode Ģ0090429 114920 Default exchange_run: exchange_validate failedĢ0090429 114920 Default dropped message from 195.100.205. The message “Payload Malformed” was received during the IKE exchange. “Payload Malformed” (Phase 1 Algorithm mismatch) Check also the logs of the remote VPN Gateway to get more information about this problem.Check in “Phase 1 advanced” the Local ID matches the value and type defined in the VPN Gateway.Check the preshared key (Phase 1) is correct and consistent on both sides of the VPN connection (Client and Gateway/peer).It means either the pre-shared key is wrong or the Local ID of the VPN Client doesn’t match the Remote ID of the VPN Gateway or peer.Ģ0090429 115317 Default (SA Cnx-P1) SEND phase 1 Main Mode Ģ0090429 115319 Default (SA Cnx-P1) RECV phase 1 Main Mode Ģ0090429 115319 Default (SA Cnx-P1) SEND phase 1 Main Mode Ģ0090429 115319 Default ipsec_get_keystate: no keystate in ISAKMP SA 00B57C50 “No proposal chosen” (Phase 2 Algorithms mismatch) Check the PFS to be activated or not on both peers (Client and Router).Warning: the local ID on the router is the remote ID on the VPN Client and conversely !.Check the VPN Client Phase 1 algorithms to be consistent with the gateway (or peer) Phase 1 algorithms.Note: this message may also be received on various values mismatches, thus it is useful you check the whole VPN configuration.Ģ0090429 115905 Default sysdep_app_open: Init Connection for : Cnx-Cnx-P2 Cnx-remote-addrĢ0090429 115905 Default sysdep_app_open: IPV4_SUBNET Network 192.168.1.1Ģ0090429 115905 Default sysdep_app_open: IPV4_SUBNET Netmask 255.255.255.0Ģ0090429 115911 Default (SA Cnx-P1) SEND phase 1 Main Mode Ģ0090429 115911 Default RECV Informational with NO_PROPOSAL_CHOSEN error You can configure the type of service-differentiated service code point (ToS. The message “No proposal chosen” was received during the IKE exchange: The Phase 1 algorithms doesn’t match the gateway configuration. (host) mynode (config) aaa authentication via connection-profile test.

Check point VPN ODE